![]() #pragma config CP = OFF // Flash Program Memory Code Protection bit (Code protection off) ![]() #pragma config WRT = OFF // Flash Program Memory Write Enable bits (Write protection off all program memory may be written to by EECON control) #pragma config CPD = OFF // Data EEPROM Memory Code Protection bit (Data EEPROM code protection off) #pragma config LVP = OFF // Low-Voltage (Single-Supply) In-Circuit Serial Programming Enable bit (RB3 is digital I/O, HV on MCLR must be used for programming) #pragma config BOREN = ON // Brown-out Reset Enable bit (BOR enabled) #pragma config PWRTE = OFF // Power-up Timer Enable bit (PWRT disabled) ![]() #pragma config WDTE = OFF // Watchdog Timer Enable bit (WDT disabled) #pragma config FOSC = HS // Oscillator Selection bits (HS oscillator) Use project enums instead of #define for ON and OFF. #pragma config statements should precede project file includes. Try this: // PIC16F876A Configuration Bit Settings
0 Comments
Leave a Reply. |